SIG100 SIG60-IC UART/LIN DC PLC TRANSCEIVER IC SIG100-IC Yamar
SIG100 UART LIN transceiver IC
,SIG60-IC DC PLC transceiver
,Yamar transceiver IC with warranty
Electronic components Integrated Circuits (ICs)
SIG100 SIG60-IC UART/LIN DC PLC TRANSCEIVER IC SIG100-IC Yamar
9.6k-115.2k Modem PSK 32-QFN (5x5) SIG60
| Category | Integrated Circuits (ICs) |
| Product Name | Electronic components |
| Model number | SIG100 |
| Mfr | YAMAR |
| Series | 9.6k-115.2k Modem PSK 32-QFN (5x5) IC |
| Package | Standard package 2500PCS/REEL |
| Condition | New and original Package |
| Lead time | In stock can be shipped ASAP |
| Features | 9.6k-115.2k Modem PSK 32-QFN (5x5) SIG100 SIG60 |
| Package / Case | QFN |
| Mounting Type | Surface mounting |
| Base Product Number | SIG100 SIG60-IC |
The SIG100 IC modulates UART/LIN bytes over the DC powerline (DC-BUS). The SIG100 is an advanced generation of the widely used SIG60 device.
Both devices use a unique multiplex digital signaling technology that overcomes the powerline noisy environment at bitrates up to 115.2Kbit/s.
A Sleep mode allows low power consumption when the device is not used.
The SIG100 power line UART transceiver reduces wiring in Automotive, Aerospace, Industrial, Lighting, Sensors, Actuators, Battery management systems (BMS), Climate control, Truck-Trailer communication, etc.
Operation
The SIG100 IC operates as a Master-Slaves UART network of multiple SIG100 ICs. Users can define their protocol since there is no limit to the number of UART bytes in a message. Furthermore, the SIG100 operates on any selectable carrier frequency between 5MHz and 30MHz with 100 kHz spacing, allowing multiple independent networks to coexist on a single powerline by using different carrier frequencies for each network.
The Figure below depicts a typical SIG100 network, demonstrating a single byte transmission from a SIG100 TX device to three SIG100 RX devices coupled through a capacitor to the same powerline. Upon detection of a start bit on the SIG100 TX device HDI pin, a modulated PLC-byte transmission starts. Then, the modulated PLC-byte is decoded back to a byte-field on SIG100 RX ICs' HDO pin at a fixed latency of ~2.5 bits.
Angel Technology Electronics CO. is a electronic components distributor since 2006.Our products incluing mixed-signal,
and digital signal processing (DSP) integrated circuits (ICs) used in virtually all types of electronic equipment .
